Installation - PETER HIRT T500 Serie Bedienungsanleitung

shall be processed
• Push back the bellow by holding the front ring with your fingers and moving this
towards the casing. You will see two areas on the shaft
• Hold with the supplied special wrench the shaft
• Release the tip with a plier
• Change the tip
• Tight the new tip with a plier
• Bring back the bellow to its initial position. Keep attention to not twist it and that
all wrinkles are properly formed

Installation

The transducer and its main parts
Number Description
1 Tip M2.5
2 Bellow
3 Shaft 8h6
4 Product and serial
number
5 Electronic
6 M8 Connector (male)
Subject to change without notice. Errors and omissions excepted
Functionality
Tip with M2.5 thread. Can be exchanged with
supplied special wrench.
Sealing Bellow made of Viton (R)
(L models seal with an air gap and therefor lack
of a bellow)
Shaft to fix the transducer in common 8h6
clamping bushes
Unique serial number for product life cycle tra-
cking. Production, recalibration and may added
accessories or made configuration changes
can be tracked with.
Housing 11h6 consisting of the conditioning and
communication electronics
Connection on M8 standard
Page 13/20