Introduction; Security Advices; Maintainence - PETER HIRT T500 Serie Bedienungsanleitung

Introduction

Digital IO-Link Transducer base on the inductive core measurement principle. They are
thus robust and measure an absolut position.
Transducers are connected via an IO-Link gateway to a PLC or IoT computing unit.
Products covered by this manual are
Article number
1005094
1005095
1005096
1005097
1005098
1005099
1005100
1005101
Detailed technical specifications can be found on our webpage www.peterhirt.com or
in the printed catalogue.

Security advices

Faulty transducer potentionally create wrong measurements. To prevent from this
periodically plausibility checks must be forseen. A well defined master piece to check
the transducer functionality shall be used.

Maintainence

Periodical check
To assure the transducer functionality and its measuring ability, every year the device
should be checked. Properties to be verified are
• a well mechanical behaviour
• the main functionalities, measuring capability and the communication
• metrology abilities as linearity, repeatability and measure value stability
This check can be done by either the manufacturer or a well trained and equipped
metrology laboratory.
M2.5 tip change
When in application the tip must be tighten. For the tip change the following steps
Page 12/20
Description
T501FIOL
T502FIOL
T501VIOL
T502VIOL
T501PIOL
T502PIOL
T501LIOL
T502LIOL
Propoerties
Spring push, +/- 5 mm stroke
Spring push, +/- 5 mm stroke
Vacuum retract +/- 5 mm stroke
Vacuum retract +/- 5 mm stroke
Pneumatic push +/- 5 mm stroke
Pneumatic push +/- 5 mm stroke
Pneumatic push +/- 5 mm stroke
Pneumatic push +/- 5 mm stroke
Manual digital IO-Link Transducer
Series T500
PRDK-0000032-DE-EN-001