Cleaning And Care; Cleaning The Water Tank - Silvercrest STLH 7 A1 Bedienungsanleitung

6. Cleaning and care

DANGER! Risk of electric shock!
Always disconnect the power unit 8 before cleaning.
Never immerse the device 5 in water.
Do not let water or cleaning agent run into the device 5.
WARNING! Risk of material damage!
Do not clean using sharp objects or abrasive cleaning agents.
NOTE: to ensure that your device 5 always functions hygienically, clean the water
tank 16 regularly and replace the filter 17 in a timely manner. Also ensure that all ac-
cessories are dry and clean when the device 5 is not in use.

6.1 Cleaning the water tank

After each use, rinse the water tank 16 thoroughly with tap water. If used regularly,
rinse the water tank 16 twice a week with warm vinegar water.
1. Pull the power unit 8 out of the wall socket.
2. Push down on the release buttons 1 and remove the front panel 14.
3. Figure A: pull the water tank 16 with the filter 17 out of the device 5.
4. Figure C: open the lid 15 of the water tank.
5. Pour out the rest of the water.
6. Add about 1 tablespoon of vinegar to 500 ml of warm tap water.
7. Fill this vinegar water mixture into the water tank 16, close the lid 15 of the wa-
ter tank and swivel it back and forth several times.
8. Then rinse the water tank 16 several times with tap water.
9. Let the water tank 16 dry completely.
10. If you do not immediately use the device 5 again, leave the lid 15 of the water
tank open.
11. Push the water tank 16 with the filter 17 back into the device 5.
12. Insert the front panel 14 at the bottom first. Then press the top towards the device so
that the release buttons 1 engage.
31
GB