5.5 Switching the device on / off
NOTES:
• Wait approx. 2 minutes until the filter 17 has absorbed sufficient water. Then you
achieve the full cooling effect.
• If the front panel 14 is not closed, the device cannot be switched on. This is a
safety function.
• Press the on/off switch
once. The fan starts to operate at speed 1 (low speed).
• Press the on/off switch
5.6 Regulating the air flow
• Press the speed control
3 speed settings:
LED 11
flashes red
1 time
2 times
3 times
• Figure D: you can influence the direction of the air flow by turning the front pro-
tective grid 13 back and forth.
5.7 Switching on the light and selecting the colour
• Press the light and colour selector switch
... turn on the light in colour change mode (slow transitions, all colours),
... to change the light colour consecutively to green, red, blue, yellow, pink, white
and turquoise,
... to turn off the light again.
30
GB
2 to switch the device on. The LED 11 flashes red
2 again to turn off the device.
3 several times in succession to switch between the
Speed
1
2
3
Speed
low
medium
high
4 several times in succession to...
Evaporation
volume
approx. 90 ml/h
approx. 120 ml/h
approx. 150 ml/h