Honda HHH25D Bedienungsanleitung Seite 43

HHH25S:
• During operation, leave the trimmed branches, leaves, etc. on the grass plate.
HHH25D:
• The rear handle can be turned to three positions (the CENTER position and 90°
clockwise, and counterclockwise).
• Upper part: Turn the rear handle to the CENTER position when you trim the
upper part of a hedge.
• Side part: When you use the cutter blade on the left side of your body, turn the
rear handle 90° counterclockwise. When you use the right side of your body, turn
the rear handle 90° clockwise (see page 41).
When you trim the side of a hedge, face the cutter blade to the hedge and face
the engine to your body.
CENTER position
40
GRASS PLATE
Turn the rear handle 90° clockwise.
Turn the rear handle
90°counterclockwise.