Product Description; Operation - Concept SM3500 Betriebsanleitung

EN

PRODUCT DESCRIPTION

1. Measuring cup
2. Lid
3. Blender jar
4. Filter
5. Blade assembly
6. Blade assembly seal
7. Blender jar base
8. Speed control
9. Pre-set programs of the appliance
10. Blender base
9
36
1
2
4
3
5
6
7
8
10
SM3500
OPERATING INSTRUCTIONS
NOTICE
Before putting a new appliance into operation, you should wipe it thoroughly from the outside with a damp cloth and
wash all removable parts in warm water for hygienic reasons.
The appliance has a built-in safety fuse. The appliance motor can only be switched on if the accessories are properly
fitted. Do not bypass the safety mechanism!
Never leave the appliance unattended while in operation or switched off, but plugged in!
Immediately after switching off the motor and unplugging the power cord, some parts may be still moving
for a while. Wait until the accessory has completely stopped before opening the lid.
CONTROLS
1. Speed control: Use the speed control to turn the appliance ON/OFF. You can also use it to determine the mixing
speed (MIN-MAX)
2. Ice Crush: Pre-set program for crushing ice. Pressing the Ice crush button will start the program. Press again to
turn it off.
3. Auto clean: Pre-set program for cleaning the appliance. After you finish mixing, empty the blender jar and pour
approx. 1 l of water into it. Press the Auto clean button. The appliance with start the automatic cleaning function.
Pressing the Auto clean button again will turn the program off (to better clean the container from the remnants
of the food prepared in it, repeat the whole cleaning procedure again).
4. Smoothie: Pre-set program for the preparation of smoothie drinks. Pressing the Smoothie button will start the
program. Press again to turn it off.
Note: Before making a smoothie drink, you can put a filter in the blender jar. It separates the seeds (e.g. from
strawberries, kiwi, etc.) from the fruit juice while mixing. For the best result of mixing with the filter, we recommend
using fresh fruits or vegetables.
Caution! If you want to choose from the pre-set programs, the speed control must be in the ON position.
If the speed control is in the ON position, the light indicators of the pre-set programs will flash slowly.

OPERATION

1. Place the container on the blender base. Before putting the appliance into operation, check that the container is
correctly seated in the base.
2. Place the food in the container and place the lid on the blender container (the recommended size of inserted food
is 2 x 2 x 2 cm). Gently press on the lid so it is sealed perfectly.
3. Connect the appliance to the mains.
4. Select a pre-set program (see Controls) or continuous mixing.
5. Remove the container from the motor base only if the motor is not running.
Note: The appliance is equipped with a safety fuse. It will not work without properly fitted jar. The appliance is
equipped with protection against overheating.
SM3500
EN
37