Back; Input Channels; Aux Channels; Recording Output - Harman AKG DMM 4/2/4 Stereo Bedienungsanleitung

Back

DMM 4/2/4 Stereo
Downloaded from www.Manualslib.com
Figure 2: Back of DMM 4/2/4
1, 3, 4, 6:
2, 5:
7,8:
9:
10a:
10b:
11a:
11b:
12:
13:
14:
15:

Input channels

The four balanced input channels can be accessed via 3-pin XLR sockets. These are labelled
"IN 1 - MIC/LINE" to "IN 4 - MIC/LINE". The input levels can be adjusted using the rotary
controls "IN 1 - MIC/LINE" to "IN 4 - MIC/LINE" on the front panel.
Between two XLR sockets there are 6-way DIP switches. This can be used to configure two
input channels in each case.
Figure 3: DIP switches for the input channels
"Phantom Pwr" - switch phantom power on/off on both audio wires of the selected channel.
"Line/Mic" - switch preamp from microphone to line input. In that case the gain is 0 dB.
"Mic-Hi/Lo" - switch gain from +60 dB to +40 dB.

AUX channels

The two auxiliary input channels can be accessed via two RCA jacks. The RCA jacks are
labelled "IN 5 - AUX" and "IN 6 - AUX". The input levels can be adjusted with the rotary
controls "IN 5 - AUX" and "IN 6 - AUX" on the front panel.

Recording output

Two RCA jacks, labelled "OUT REC", are available for connecting recording equipment. A
mono signal is present at each of the two jacks.
manuals search engine
Input channels
DIP switch
AUX channels
Recording output
Stereo output channel, left
Stereo output channel, right
External control connection
PC connection
Expansion connectors
Ground lift switch
Mains switch
Mains connection
OFF
1 2 3 4 5 6
IN 1 - MIC/LINE IN 1 IN 2 IN 2 - MIC/LINE
Description
OFF
1 2 3 4 5 6
IN 4 - MIC/LINE
IN 3 - MIC/LINE IN 3 IN 4
33