Acco GBC C95 Bedienungsanleitung Seite 5

Select the correct plastic comb
Place the document against the size selector and note the
1
suggested comb element size.
Use the comb element size guide if you wish to confirm the
size of the comb element you are using.
Place one end of the comb element against the different
2
profiles in turn to find the appropriate profile.
The separate comb opening mechanism allows you to
collate the documents on the comb whilst punching more
pages, giving you a quicker binding cycle.
Inserting and opening the comb
Close the 'comb operating mechanism' by turning the
1
'comb opening knob' clockwise.
Place the plastic comb open side up on the comb opening
2
mechanism. [Fig. 1]
Open the comb by turning the 'comb opening knob'
3
anticlockwise.
Paper edge alignment
• Rotate the green knurled wheel to move the edge guide to
the required setting of A4, 11" Letter or US Cover. [Fig. 2]
Punching the document
Insert the sheets into the punching channel and align to the
1
edge guide. [Fig. 3]
Support the machine and lower the raised handle to punch.
2
[Fig. 4]
Guarantee
Operation of this machine is guaranteed for two years from
date of purchase, subject to normal use. Within the guarantee
period, ACCO Brands Europe will at its own discretion either
repair or replace the defective machine free of charge.
Defects due to misuse or use for inappropriate purposes are
not covered under the guarantee. Proof of date of purchase
Register this product online at www.accoeurope.com
Downloaded from www.Manualslib.com manuals search engine
Comb binding
Load the front cover onto the open comb and lower it
1
towards the front of the machine. [Fig. 5]
Load the internal sheets onto the open comb, repeating
2
until all are loaded.
Load the rear cover onto the open comb.
3
Rewind the comb opening knob and remove the bound
4
document.
Correcting a bound document
• Additional sheets may be included or removed at any time
by opening and then closing the comb binding as described
previously.
Emptying the waste tray
Important: The waste tray must ONLY be emptied with the
machine supported in a upright position.
Stand the machine upright.
1
Unclip the tray from the underside of the machine. [Fig. 6]
2
When refitting the tray ensure that it clicks firmly into place
3
before returning the machine to normal operation.
Storage
• Lower the handle, if raised.
The machine incorporates feet at the rear to allow vertical
storage.
Security
• A Security Slot is fitted for use with leading makes of security
leash. E.g.: Kensington Microsaver.
will be required. Repairs or alterations made by persons
not authorised by ACCO Brands Europe will invalidate the
guarantee. It is our aim to ensure that our products perform to
the specifications stated. This guarantee does not affect the
legal rights which consumers have under applicable national
legislation governing the sale of goods.
G