Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
20
DESCRIPTION
This charging station is used for charging electric vehicles (EV's) and is
compatible with the common IEC61851 standard.
This unit includes a charging station, 1 (single phase) or 3 (3-phase) current
clamps (CT's) and a sensorbox V2.
The sensorbox measures the current (direction) of the power in the electrical
cabinet and transmits this information to the charging station.
When other appliances are switched on, the power to the EV will automatically be
reduced.
It is also possible to charge the EV on pure solar power. The charging station uses
the sensorbox to try to send all generated power from the solar panels to a
charging EV.
INSTALLATION
1.
The installation must be done by a qualified and licensed electrician
according the local legislation.
2.
The electrical installation must be free of power during the entire
installation period.
3.
Since this Charging Unit uses circuits that reference to ground, no
Megging must be done after connecting to power.
4.
Wiring and protection:
Version
32A / 1 Phase
3G6,00mm
32A / 3 Phase
5G6,00mm
*
For cable length upto 25m
PLEASE NOTE:
www.ratio.nl
www.ratio.nl
Wiring *
Mains Circuit Breaker
40A B/C-Characteristic
2
2
40A B/C-Characteristic
All charges include an AC (> 30mA) and
DC (> 6mA) residual-current-detection.
Always place a type A RCD and the MCB
(or combination unit) in the electrical
cabinet.
Residual Current Device
(MCB)
(RCD)
30mA, Type A
30mA, Type A
Werbung
Inhaltsverzeichnis
