Connection Diagrams - Alto Professional Rmx1008Dfx Kurzanleitung

CONNECTION DIAGRAMS

MAIN SPEAKER CONNECTION
Please use only the power connectors to make connections with other signal source equipment for the passive
speaker cabinets. In normal condition, the terminals 1+ and 1- of the speakon connecter can be connected. In bridge
mode, the terminals 2+ and 1+ of the speakon connecter can be connected.
This is the most common application. The built-in amplifier drives two main speaker cabinets Left and Right. The
AMPLIFIER MODE is on MAIN+MAIN position.
WARNING: In MAIN + MAIN mode, the speaker loads of OUTPUT1 and OUTPUT2 cannot be less than 4 ohm or it
will damage the unit.
Downloaded from www.Manualslib.com
Speakon connector
MAIN + MAIN
Main
Speaker
Main
Speaker
manuals search engine
Use either the Speakon jacks
or 1/4" jacks
7