Syris Scientific v300 Benutzerhandbuch Seite 14

v600 Illuminator Module Replacement
1) Turn off the v600 Visualization System and disconnect the AC Power Input
2) Allow the old Illuminator Module to cool at least ten minutes before
3) Remove the new Illuminator Module from the packing tube. Enclosed in the
4) Remove the old Illuminator Module from the optics tube by rotating it counter-
5) With a gloved hand, remove the new Illuminator Module from its plastic
IMPORTANT! Do not allow the Illuminator Module bulb or reflector to come
in contact with exposed skin or other foreign material. This may cause
premature failure of the Illuminator Module.
6) Install the new Illuminator Module in the optics tube by screwing it clockwise.
IMPORTANT! Do not force the new Illuminator Module into the optics tube.
If you are having difficulty installing the new Illuminator Module, rotate it
counter-clockwise one turn and then re-attempt to gently screw it into the
optics tube. Figure 5: Removal of v600 Illuminator Module.
7) Connect the Upper DC Power Cable to
8) Turn the system on and make sure the
Doc #5002 (English) 07/2004
Downloaded from www.Manualslib.com
Cable from the wall outlet. Disconnect the Upper DC Power Cable from the
old Illuminator Module.
proceeding.
packing tube is a cotton glove. Please use this glove for handling the new
Illuminator Module.
clockwise as shown in Figure 5.
wrapper.
the Illuminator Module, and plug AC
Power Input Cable into a wall outlet.
both the lamp and fan are functioning.
manuals search engine
v300/v600 Owner's Manual
Figure 5. Removal of v600 Illuminator Module
13