Syris Scientific v300 Benutzerhandbuch Seite 10

Wiring Setup (See Figures 1 or 2)
1) Plug the Upper DC Power Cable into the back of the Illuminator Module.
2) Plug the phone plug of the Upper DC Power Cable into either side of the Power
3) Plug the phone plug of the Lower DC Power Cable into the remaining side of
4) Plug the female DIN connector of the Lower Power Cable into the male DIN
5) Plug the IEC connector of the AC Power Cord into the IEC port on the Power
6) Plug the AC plug of the AC Power Cord into an approved outlet.
After completing the wiring setup procedure, turn the switch of the Power Control
Module to on. You should immediately hear the fan of the Illuminator Module turn
on. To prevent shock to the Illuminator Module, the system is designed to gradually
turn on the Illuminator over a five second period.
IMPORTANT! If there is no evidence of the light or fan when you turn the
system on, immediately turn off the Power Control Module. Check the wiring
setup again.
Doc #5002 (English) 07/2004
Downloaded from www.Manualslib.com
Control Module.
the Power Control Module.
connector of the Power Supply.
Supply.
manuals search engine
v300/v600 Owner's Manual
9