Product Operation - Syris Scientific v300 Benutzerhandbuch

Syris Scientific, LLC

Product Operation

The v300/v600 Visualization System is intended to enhance the vision of medical
professionals when used in the patient environment during inspections and
procedures.
The v300/v600 Visualization System is designed to enhance the surface or the sub-
surface features of a patient's skin. This is accomplished by parallel-polarizing or
cross-polarizing the light emitted from the Illuminator Module. To change between
surface and sub-surface viewing mode, use the following simple procedure:
1) While wearing the Headgear, locate the Illuminator Module with your free hand.
2) Slide your hand down the Illuminator Module until you locate the adjustment
peg located at the front of the barrel.
3) Gently grasp the adjustment peg and rotate it as shown in Figure 4.
4) As worn on the head, the surface (parallel-polarized) mode will be seen
when the adjustment peg is at the 10 o'clock position. The sub-surface
(crossed-polarized) mode will be seen when the adjustment peg is at the
2 o'clock position.
NOTE: In order to observe the effects of the system, the user must be looking
through the Visi-Shield
10
Downloaded from www.Manualslib.com
Sub-Surface
Figure 4. Polarization Adjustment
manuals search engine
Surface
www.syrisscientific.com