Oregon Scientific BAR938HG Bedienungsanleitung Seite 4

4. Insert the batteries strictly according to the polarities shown
therein.
5. Replace the battery compartment door and secure its screws.
Replace the batteries when the low-battery indicator of the particular
channel lights up on the main unit. (Repeat the steps described in
section "BEFORE YOU BEGIN")
Note that once a channel is assigned to a remote unit, you
can only change it by removing the batteries or resetting the
unit.
BATTERY INSTALLATION: MAIN UNIT
1. Gently press and lift the tab on the battery compartment door.
2. Insert four UM3 or AA-size batteries.
3. Replace the battery compartment door.
Replace the batteries when the low battery indicator [
the weather forecast window lights up.
HOW TO USE THE BACKLIGHT
Press the SNOOZE/LIGHT button once. The backlight will be
turned on for five seconds.
TIME DISPLAY MODES
The current time and date can be displayed in three modes: hour-
minute-second, hour-minute-weekday and day-month-year or
month-day-year. Press the MODE button to change from one mode
to the other.
Pressing the ALARM button during any of these modes will
display the daily alarm time. Another press will go to the Pre-alarm
mode. To go back to normal time and date display, press MODE.
Downloaded from www.Manualslib.com manuals search engine
ABOUT RADIO RECEPTION
BAR938HG is designed to automatically synchronize its calendar
clock once it is brought within range of the Frankfurt DCF77 radio
signal. It will scan and adjust every full hour.
When BAR938HG is within range, its radio-control mechanism
will override all manual settings.
When the unit is receiving radio signal, the RADIO RECEPTION
indication will start to blink. A complete reception generally takes
about two to 10 minutes, depending on the strength of the radio
signal.
When the reception is complete, the RADIO RECEPTION indication
will stop blinking. If the signal is received, a RADIO RECEPTION
indication [ ] will be shown. Otherwise, [
For better reception, place the clock away from metal objects and
electrical appliances to minimize interference.
Should you wish to deactivate the RF controlled function, press
MODE and DOWN button simultaneously.
To reactivate the RF control function, from its deactivated status
press MODE and UP simultaneously.
] on
HOW TO SET THE CLOCK AND
CALENDAR MANUALLY
When the current time is displayed, press and hold MODE for
three seconds. The 12-hr or 24-hr digits will flash. Use the UP or
DOWN button to select either. If 12-hour clock format is selected,
the time will be displayed with the AM or PM indicator.
Press MODE. The hour digits will flash. Use the UP or DOWN
buttons to enter the hours. Holding down either button will increase
or decrease the value rapidly. Press MODE to go to the minutes. Set
the minutes like you set the hours. Press MODE to confirm.
If changes are made during minute-setting, the seconds will clear to
zero and stop.
The year digits will flash. Enter the year using the UP or DOWN
button.
Press MODE. The "DM" or "MD" indicator will flash. Use the
UP or DOWN button to select "DM" for day-month display or
"MD" for month-day display.
Press MODE and follow the same procedure to set the month and
day.
Press MODE. The E, D, F, I or S language indicator will flash.
3
] is displayed.
- Good
- No signal
- Receiving