Troubleshooting; Initial Use - Interline 57100025 Bedienungsanleitung

4) Close the water feed to the pool on the inlet nozzle.
(Illustration 7)
5) Ensure that all water bearing pipes are closed.
(illustration 8)
6) Remove the pipe between the filter pump and inlet nozzle.
Unscrew the connection directly at the inlet nozzle only.
(Illustration 9)
7) Connect this pipe to the solar collector only (Illustration 2
point A) and fasten this with a hose clip. (Illustration 10)
8) Attach the hose Ø 38 mm included to the outlet side of the
solar collector (illustrations 2 point B, and 11) and the
other end to your pool's inlet nozzle. (Illustration 12)
9) Turn the aluminium supporting poles to the vertical
position, and adjust the poles to the appropriate length.
Hold the end of aluminium pole, and turn it clockwise to
lock the aluminium pole.(Illustration 13, 13a, 13b, 13c)
10) Remove the protective covering on the upper side of the
collector. (Illustration 14)
Connecting several collectors:
If you would like to increase the heating power, you can connect
several collectors together. (Illustration 17) For this you will need
a additional swimming pool hose Ø 38 mm.
We recommend connecting a maximum of 2 collectors,
depending on the power of your filter unit.
We definitely recommend use of a bypass set.
Not only does this help optimal control of heat output, it also
helps targeted control of the water flow rate, depending on the
power of the filter unit.

4 INITIAL USE

Once the solar collector is assembled and the hoses are
connected to the filter pump and the pool, open the water
supply and ensure that water is flowing through the hose. Then
turn on the filter system. Air bubbles will rise from the inlet
nozzle in the pool. This happens as the air is expelled from the
solar collector. If this continues formore than 2-3 minutes, check
the tightness of the connections in your system.
Please note: Cover your pool overnight to avoid loss of
heat.
5 TROUBLE SHOOTING
Problem Cause / Solution
»
The pool does not Make sure that water is flowing
warm up. through the hoses.
»
Has it been sunny enough?
»
Exploit the maximum amount of
sunlight and increase the running
time of the filter pump.
»
Cover your pool overnight to
avoid loss of heat.
»
It is possible that you may need
several solar collectors.
»
No bubbles appear Check the filter system and ensure
after the equipment that water from the pool is flowing
has been attached to through the filter pump, then
the pump. through the solar collector and
finally through the connect- or
hose back to the pool.
»
Air bubbles come out Check the connector hoses for any
of the pool return damage.
»
after the pump has Check that the hose clamps have
been turned on. been properly tightened.
»
Water escaping. Check the seals in the system of
pipes.
»
Check whether you have
tightened the hose clamps tightly
enough.
»
Check the connector hoses for any
cracks.
5