Setting Up Your Machine; The Position Of Thread Pole; Cone Holders; Spool Caps - AEG 3500 Bedienungsanleitung

SETTING UP YOUR MACHINE

Set your Overlock machine on a sturdy flat
surface.

[ THE POSITION OF THREAD POLE ]

Pull up thread pole to its highest point before
threading.
Turn the thread pole so the thread guides
come right above the spool pins.

[ CONE HOLDERS ]

Both industrial cones and domestic type thread
spools can be used on this machine.
For large diameter industrial cones use the
cone holders with the large end at the top.
For small diameter cones. use the same cone
holders with the small end at the top.

[ SPOOL CAPS ]

When using domestic type thread spools,
remove the spool holders and place spool
caps over the thread spools.
Downloaded from www.Manualslib.com manuals search engine
Positioning catches
Spool holder
Spool cap
Notch
( 6 )
Normal
Domestic type
thread spool