Set Pre-Alarm; Activate Alarm - Oregon Scientific BAR321 Bedienungsanleitung

5. The beep alarm icon
will flash. Press UP or DOWN to confirm the
alarm mode. Press ALARM /
or shows when the Alarm is set.
NOTE The AC Adapter must be connected for the
Talking Alarm to work. If you select Talking Alarm, and
the Adapter is not plugged in at the alarm time, the Beep
Alarm will sound.

SET PRE-ALARM

The Pre-Alarm can be set to sound 15,30,45, or 60 minutes
before the Daily Alarm. It will sound whenever the recorded
temperature from Channel 1 Sensor falls to 2°C (35.6°F)
or below.
For example, if you set the Alarm to 7:00 AM, and the
Pre-Alarm to 45 minutes, the Pre-Alarm will sound at
6:15 AM provided the outdoor temperature at Channel 1
Sensor is 2°C or below.
1. Set up and activate the Daily Alarm.
2. Press ALARM /
( will show at the top.)
3. Press and hold ALARM /
BAR321/323HGN English New R2 OP
Downloaded from www.Manualslib.com
or talking alarm icon
to confirm.
to switch to Pre-Alarm view.
for 2 seconds.
14
Black
manuals search engine
4. Press UP or DOWN to select 15, 30, 45 or 60 minutes.
This is the amount of time the Pre-Alarm will sound
BEFORE the Daily Alarm. The Pre-Alarm is
automatically activated when you select a time.
5. Press ALARM /
shows when the Pre-Alarm is set.
NOTE The daily Alarm will NOT function until the next
day once if the Pre-Alarm has been triggered. Also, if
you deactivate the Alarm, the Pre-Alarm is automatically
deactivated.

ACTIVATE ALARM

Navigate to the Clock Area, then press ALARM /
switch to Daily Alarm or Pre-Alarm view. To activate or
deactivate the alarm, press UP or DOWN.
When the Alarm time is reached, the crescendo alarm
will sound for 2 minutes. Press any key to silence the
alarm. It will sound at the same time the next day.
14
to confirm.
8/17/04, 12:55 PM
to