Set Clock; Alarms; Set Daily Alarm - Oregon Scientific BAR321 Bedienungsanleitung

The house icon
indicates that the
radio-controlled
clock is ON. No
icon means that it
is OFF.

SET CLOCK

You only need to do this if you have disabled the radio-
controlled clock, or if you are too far from a RF signal.
1. Press SELECT to navigate to the Clock Area.
will show next to the Area.
2. Press and hold MODE for 2 seconds.
3. Select the 2
12/ 24 hour format, hour, minute, year, date/month
format, month, date, and display language, and
(optional) volume level for the Audio Broadcast.
Press UP or DOWN to change the setting. Press
MODE to confirm.
BAR321/323HGN English New R2 OP
Downloaded from www.Manualslib.com
nd time zone offset hour (+/-23 hours),
13
Black
manuals search engine
NOTE
The language options are (E) English,
(F) French, (D) German, (I) Italian, and (S) Spanish. The
language you select determines the weekday display
and the spoken language for the Audio Broadcast.
NOTE
Audio Broadcast must be activated (
before you can set the volume level. The number of bars
shown after the speaker icon (
the display indicates the level (Low, Medium, or High).

ALARMS

This product has 2 alarms: the Daily Alarm and a Pre-
Alarm for snowy weather. The Daily Alarm can be set to
go off at the same time every day and you can select
either Beep or Talking Alarm. The Pre-Alarm sounds only
when the Daily Alarm is activated and the recorded
temperature from Channel 1 Sensor falls to 2°C
(35.6 °F) or below.

SET DAILY ALARM

1. Press SELECT to navigate to the Clock Area. will
show next to the Area.
2. Press ALARM /
at the top.)
3. Press and hold ALARM /
4. Select the hour and minute. Press UP or DOWN to
change settings. Press ALARM /
13
8/17/04, 12:55 PM
) at the BOTTOM of
to view the Alarm. (AL will show
for 2 seconds.
to confirm.
19)