DJI T Serie Bedienungsanleitung Seite 6

5. For the Spreading System 2.0, there is the option to mount the fender to the spreader. If mounted, the fender will
prevent materials from being spread to the rear of the aircraft.
5 cm
6. Connect the Spreading System cable:
T20
Pass the cable through the space between the delivery pumps and spread tank mounting position. Secure the
cable to the cable strainer on the left of the aircraft, connect it to the EMF/Liquid Level port, and tighten the two
M2.5×8 screws.
T16
a. Remove the M3×8 screws on both sides of the spray control board. Lift the board gently to make a space
between the board and the mounting position. DO NOT pull the cables connected on the board.
b. Pass the cable through the space between the delivery pumps and spread tank mounting position, then
through the space under the spray control board. Connect the cable to the EMF/Liquid Level port and
tighten the four M2.5×8 screws.
c. Remount the M3×8 screws on both sides of the spray control board.
7. Remount the cable strainer protector (for T20 only) and the upper cover of the aircraft. Tighten the five M3×8
screws and attach all of the rubber stoppers.
2
1
M2.5×8
M2.5×8
M3×8
© 2020 DJI All Rights Reserved.
5