Toro Power Plex 51138 Bedienungsanleitung Seite 21

Figure 31
11. Feed the chain around the guide bar and align
the chain teeth into the groove of the bar.
12. Position the open loop of the chain (not on the
guide bar) around the drive sprocket on the
chain saw and install the guide bar and attached
chain onto the chain saw as shown in
Important:
Ensure that the chain adjusting
stud is inserted into the hole indicated by the
arrow in Figure
the chain tensioning knob to fit the stud into
the hole in the guide bar.
13. Install the cover and the wing nut, but do not
fully tighten the wing nut
wing-nut tab.
14. Adjust the chain tension; refer to
Chain Tension (page
Sharpening the Chain
Service Interval: Before each use or daily
Yearly or before storage
Figure
31C. You may need to rotate
(Figure 31D). Fold the
Adjusting the
18).
The chain needs sharpening or replacement when
you must force it onto the wood or it produces smaller
chips than when it was new.
Contact an Authorized Service Dealer to have the
chain sharpened or replaced.
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Recycle or properly dispose of lithium-ion battery
packs at a battery recycling facility.
Service
Should the chain saw need service, take the product
to your Authorized Service Dealer.
g192112
31.
20
For more information on recycling lithium-ion
battery packs and to locate the battery
recycling facility closest to you, visit
www.Call2Recycle.org (US and Canada only).
If you are located outside of the US and
Canada, please contact your authorized Toro
distributor.