Prolux Rolling Code K1940-s01 Originalbetriebsanleitung Seite 9

Original instructions - Rolling Code relay receiver
9. Programming of the transmitter / configuration of the outlets
Complete deleting of the settings:
In order to delete all programmed transmitters from the receiver, the following procedure
should be performed:
- The programming button must be pressed briefly. The red LED starts flashing.
- Now press the programming button again and hold for approx. 5 seconds.
- After releasing the programming button the red LED flashes 5 times in a row to indicate
that the deleting process has been finalised.
All programmed transmitters are now deleted and the receiver is back on factory setting.
Programming of new transmitters:
Up to 10 transmitters can be programmed via the receiver. In order to programme a new
transmitter, the following procedure should be performed:
- The programming button must be pressed briefly. The red LED starts flashing for approx.
10 seconds.
- Simultaneously, any button of the teach-in transmitter (no matter which one) must be
pressed. The programming button must not be pressed again while the programming
process is still under way.
The successful programming of the transmitter is confirmed by extended lighting of the
LED.
- For the programming of an additional transmitter, please repeat the two steps.
You can only programme transmitters which are within close proximity of the receiver
module! All programmed transmitters behave absolutely identically during normal opera-
tion.
What to do in case of incorrect programming:
It is possible that the receiver does not function as desired if the programming button
has accidentally been pressed twice before a button of the transmitter has been pressed.
In that case the receiver needs to be reset on factory setting (see „completed deletion of
settings") and the transmitters in use must be re-programmed.
9