Inhaltsverzeichnis
Werbung
System preparation (continued)
HT-SB350(W)
HT-SB350(BK)
ENGLISH
To mount the unit on the wall
Caution:
Be very careful to prevent the unit [1.90kg (4.19lbs.)] from
falling when mounting on the wall.
Before mounting, check the wall strength. (Do not put on the
veneer plaster or whitewashed wall. The unit may fall.) If
unsure, consult a qualified service technician.
Mounting screws are not supplied. Use appropriate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur or the unit
may get damaged.
SHARP is not responsible for accidents resulting from
improper installation.
Driving screws
SHARP designed the units so you may hang them on the wall.
Use proper screws (not supplied). See below for size and type.
5 mm
(3/16")
E-7
HT-SB350_A6_EN_UK.fm
Downloaded from
www.Manualslib.com
3.2 mm (1/8")
9 mm (3/8")
Min. 22 mm (7/8")
2010 August 16
manuals search engine
Wall mount angle fixed to the wall
(Horizontal position)
1
Fix the pattern paper to the wall in horizontal position
as below.
509 mm
Wall surface
44 mm
29 mm
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
32 mm (1-1/4")
8-9 mm (3/8")
Wall surface
3
Fix a wall mount plug into the hole using a hammer,
until it is flush with the wall surface.
32 mm (1-1/4")
8-9 mm (3/8")
Wall surface
44 mm
29 mm
Pattern paper
(Continued to the next page)
Werbung
Inhaltsverzeichnis
