Cisco 200-Serie Kurzanleitung Seite 8

C
AUTION
The Getting Started window displays. You are now ready to configure the
switch. Refer to the
for further information.
Troubleshoot Your Connection
If you cannot access your switch from the web-based interface, the switch
may not be reachable from your computer. You can test network
connections by using ping on a computer running Windows:
S 1
TEP
S 2
TEP
Pinging 192.168.1.254 with 32 bytes of data:
Reply from 192.168.1.254: bytes=32 time<1ms TTL=128
Pinging 192.168.1.254 with 32 bytes of data:
Request timed out.
Possible Causes and Resolutions
No Power:
Power up the switch and your computer if they are turned off.
Bad Ethernet connection:
Check the LEDs for proper indications. Check the connectors of the
Ethernet cable to ensure they are firmly plugged into the switch and
your computer.
8
Downloaded from www.Manualslib.com
Make sure that any configuration changes made are saved to
the Startup configuration before exiting from the web-based
interface by clicking on the Save icon. Exiting before you
save your configuration will result in all current changes
being lost the next time the switch is rebooted.
Cisco 200 Series Smart Switch Administration Guide
Open a command window by using Start > Run and enter cmd.
At the Command window prompt enter ping and the smart switch
IP address. For example ping 192. 1 68. 1 .254 (the default IP address
of the smart switch).
If you can reach the switch, you should get a reply similar to the
following:
If you cannot reach the switch, you should get a reply similar to the
following:
manuals search engine
200 Series Smart Switches