Troubleshooting - Chal-Tec Workspace GO Plus Bedienungsanleitung

TROUBLESHOOTING

Problem
The treadmill will not
turn on.
The treadmill is
spinning.
The treadmill stops
when you step on it.
The treadmill is not
centered.
The treadmill stops
suddenly.
Possible cause
The power plug has not
been inserted.
The safety key has not
been installed correctly.
The fuse in the house
is out.
The treadmill's circuit
breaker has been
activated.
The treadmill was not
tensioned tight enough.
Not enough lubricant
has been applied to the
running deck.
The treadmill has been
over tensioned.
The treadmill belt
tension is not even
above the rear roller.
The safety key has
been removed.
Suggested solution
Insert the power plug
into a wall outlet.
Install the safety key
correctly.
Reinsert the fuse or
contact an electrician
to replace the fuse.
Wait 5 minutes and try
turning the treadmill on
again.
Adjust the treadmill
voltage.
Apply lubricant.
Adjust the treadmill
tension.
Center the treadmill.
Attach the safety key.
EN
37