Control Panel; Commissioning And Operation - Chal-Tec Workspace GO Plus Bedienungsanleitung

CONTROL PANEL

1 Steps
2 Time / Speed
3 Calories / Distance
4 IR sensors
5 Speed up / down (increases or decreases the speed by 0.1 km/h)
6 Start / Stop

COMMISSIONING AND OPERATION

1
Remove the protective film from the
control panel. Place the treadmill
in a suitable location. Straighten
the handlebar by stepping on the
handlebar release under the folded
handlebar. Pull the handlebar up
until it clicks into place and the
release lever springs into the locked
position. Do not use the device
without the handlebar mounted!
2
Insert the power cord into the front
of the treadmill next to the red
power switch and make sure the
plug is oriented correctly. Plug the
other end of the power cord into a
grounded power outlet. Turn on the
power switch. A tone will sound, the
treadmill's display will illuminate and
the display will show line markings.
EN
25