Chal-Tec Workspace GO Plus Bedienungsanleitung Seite 26

EN
26
3
Remove the protective film from the
remote control.
Note: The Treadmill will not run if the safety clip is not on the handlebars
and the display will only show line markings.
5
Stand on the foot rails and turn on
the treadmill by pressing the power
button on the remote control. Make
sure the remote control is pointing
at one of the ir sensors. The display
will count down and the treadmill
will start moving.
4
Attach the safety clip to the
handlebars and make sure that it is
in contact with the magnet. Attach
the clip to clothing when using the
Treadmill. If you want the Treadmill
to stop immediately, remove the
Safety Clip from the handlebars and
the Treadmill will stop automatically.
To continue after removing the
safety clip, place the clip back on
the handlebars and press the power
button on the remote control.
6
Adjust the speed of the treadmill
by pressing the Speed up/down
buttons on the remote control.