Chal-Tec Workspace GO Plus Bedienungsanleitung Seite 27

Installing the smartphone holder
1
Pull the smaller
clip apart and
slide it around the
handlebars.
Note on handling error codes
If an error code appears on the display, check the following procedure:
• Make sure that you are using the adapter supplied.
• Make sure that there are no moving parts stuck. If they are stuck, carefully
loosen the parts or remove all blockages.
• Make sure that there is sufficient lubrication between the belt and the
deck. If not, follow the procedure described in the LUBRICATION section.
2
Insert the phone into
the larger clip and
secure it in small
grooves, inside the
clip.
3
Turn the phone in the
desired direction.
EN
27