Connecting The Tv Set And Surround Speakers To The Decoder - T&A DD 820 M Betriebsanleitung

Connecting the TV set and the surround loudspeakers to the decoder:
Connect the components as shown in wiring diagram 1.
This is the procedure:
• Connect the REAR RIGHT, REAR LEFT and CENTER
surround loudspeakers - if present - to the appropriate
output terminals on the decoder.
• If you have an active subwoofer, connect its input to
SUB OUT.
• Connect the TV socket on the decoder to your TV set
using an S-video / video cable and adaptor.
• Finally connect the mains lead and switch the system
on.
• To use the decoder your television must be correctly
configured. The essential settings include the following:
Select the picture norm matching the source
devices connected to the TV.
Some source devices can supply a range of different
picture norms, and some TV sets can only process one
norm; If problems arise in this respect, it will sometimes
be necessary to select the standard Video norm for all
the machines in the system, as this is generally
supported by all devices.
• When you have entered the correct settings in your TV
set, the next step is to check the connection between
TV set and decoder. This is done by calling up the
'Device Setup' on the decoder:
Press the 
operations.
• The menu should now appear on the screen. If it does,
close it by pressing the 
• If the menu does not appear, or if the picture is
monochrome or unstable, read the 'Trouble-shooting'
section in these operating instructions.
Downloaded from www.Manualslib.com
 button during surround mode  
 button again briefly.  
manuals search engine
If you have a  TV 720, TV 820 or TV 920 television,
please set it up as follows:
Configuring the TV 720, TV 820 or TV 920
No. F1
button
   
1 Call up TV menu
 
 
2 Equipm. configuration
red
 
 
3 Device connections
yellow
   
4 Euro 1
blue
   
Laser Disk (DVD)
5
   
6 Store
 
 
7 Signal type selection
red
 
 
8 Constant AV mode 'YC in'
 
 
9 Store
   
Back in menu
10
   
Back in menu
11
   
Station settings
12
white
   
TV station table
13
blue
   
Select programme position 0
14
   
Signal
15
white
   
Euro 1 Laser Disk
16
yellow
   
Store
17
   
Quit menu
18
Programming the function button 
format switching (4:3 / 16:9):
   
1 Call up menu
 
 
2 Device configuration
red
 
 
3 Function button
blue
   
4 Select function button
   
Select 'Picture Format' function
5
   
6 Store
 
 
7 Return to menu
   
Quit menu
8
57
Select / activate
Menu point
 for picture  