Troubleshooting - Zipper Maschinen ZI-RPE160C Betriebsanleitung

21

TROUBLESHOOTING

Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
If you feel unable to carry out necessary repairs properly and/or do not have the required skills
to do so, always call in a specialist to solve the problem.
Fault
Motor does not start
Motor stops
Engine does not deliver
enough power:
Insufficient vibration
Machine does not move
freely
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE160C
W A R N I N G
Possible cause / remedy
Check O /O

N FF
"O ".
N
Check fuel supply.

Check engine oil level (a sensor prevents starting if oil

level is too low).
Make sure that the spark plug ignition cable is

connected.
Check spark plug

Check carburettor and air filter and make sure they are

clean.
Check fuel supply.

Check that the fuel tap is open.

Check oil levels.

Check the condition of the air filter.

Check fuel supply.

Check that the fuel tap is open.

Check the condition of the air filter.

Check throttle position

Check whether the V-belt slips or is lost.

Check throttle position

Check the underside of the disc for buildup.

TROUBLESHOOTING
switch and make sure it is positioned to
35