Normal Operation - idinio 140190 Installationsanweisung

Pairing the dimmer with the Idinio-App
1. Turn the lamp on manually, by pressing the dimmer-button-axis (C).
2. Press the reset-button (R) and hold for 5s, until the red indicator-light(A) starts to flash.
3. Open the Idinio-App and press the „+"-symbol on the upper right corner of the screen.
The following depends on your version of the idinio-App;
4. Either pick „dimmer" in the „lighting"-tab, or if there is no dimmer present to choose, open
tab „electrical accessories" and pick „switch"
5. Follow the instructions in the app.
6. When your dimmer is succesfuly paired with the app, it will be displayed in the app and
the indicator-LED (A) will stop blinking.
7. Test the dimmer via the app.
8. Mount the dimmer coverplate and knob.
If pairing the dimmer fails, check if you turned the dimmer on manually first, then repeat the
pairing-process from step 1.

Normal operation

Press knob to turn ON / OFF.
Turn the knob to the right to increase the brightness to the maximum value.
Turn the knob to the left to reduce the brightness to minimum.
Problems with dimming? For example:
• flickering
• Occasional brightness fluctuations
• Lamp at lowest dimming level too bright
Setting the minimum brightness usually leads to a perfect dimming result.