Thermal Overload Protection - idinio 140190 Installationsanweisung

Installation manual
Important!
It is dangerous if people without proper training work on an electrical installation.
These should only be carried out by a qualified electrician.
This dimmer must be protected on the installation side with a circuit breaker that complies with the
regulations.
Warning : electrocution hazard
There may be a dangerous voltage at the output of the dimmer!
When working on the wiring always switch off the mains voltage. Failure to observe this warning may
result in death or serious injury.
Note:
Operating at elevated temperatures or voltages may activate thermal protection.
In this case reduce the connected load to avoid this again.

Thermal overload protection

Integrated thermal protection circuit. At a dimmer internal temperature of 110°C
The temperature overload-protection is triggered and remains activated until the temperature has
dropped to approximately 75 °C.
If this happens more often, please reduce the load.
Properties:
• Suitable for ON / OFF or AC switching
• Minimum load 3-5 W with capacitive or resistive load
such as dimmable LED lighting, incandescent lamps, high-voltage halogen and low-voltage halogen
lamps with electronic transformer.
• Soft-start operation to extend the life of the lamps.
• User setting for the lower brightness value.
• Built-in thermal cut-out to protect the dimmer at high operating temperature caused by overload.
• Meets CE and international safety standards.