Setting the minimum(B) and maximum(D)
Brightness to avoid flickering of connected
loads, or just to set your preference.
Minimum Brightness:
1. Remove the front panel cover, turn on the lamp (least brightness)
2. Turn the button „Min(brightness) (B)" to adjust the brightness down to the desired level
of the min. brightness.
Maximum Brightness:
1. Remove the front panel cover, turn on the lamp (highest brightness)
2. Turn the button „Max(brightness) (D)" to adjust the brightness up to the desired level of
max. brightness.
WiFi installation and use with Idinio-App:
in two situations, it is advised that you perform a factory-reset of the WifI-dimmer:
•
After first electrical installation and powering the dimmer up for the first time.
•
If you change your WiFi-router
Perform a factory-reset, by pressing the reset-button (R) for 5s, until the red light (A) starts
to flash.