Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
References
1.
Changing the RAID mode will cause data lost.
2.
Please refer to the instructions when switching the RAID mode, otherwise set up might fail.
3.
When using RAID function, HDDs with the same brand, model and capacity are strongly recommended.
4.
When using RAID function, more than one HDD partition is not recommended.
5.
Under Windows
, users can enable GPT when initializing drives with a total capacity of more than 2 TB.
®
6.
If users enable MBR by mistake, in order to clean the partition table, you have to switch to another RAID mode
and do the RAID mode switch all over again referring to Setup. Then go back to the RAID mode you want, repeat
the previous actions and enable GPT when initializing drives.
7.
For macOS
users: the total capacity of more than 2 TB could be recognized only for the operation system is
®
10.4.1 1 Tiger or later.
8.
Rebuild time is based on the capacity, e.g. it takes about 1 hour for 200 GB.
9.
When the USB cable is plugged out, the device goes to sleeping mode automatically.
10. Setting up motherboard's power management in S3 is recommended. (For more details, please refer to the user
guide of motherboard BIOS setting).
1 1. If the device takes too long to initialize, please check if the drive is securely installed.
12. If there is any unusual noise with the fan, take out the fan, pull out the power cord, clean the fan and assemble it
back.
If the noise is still present, replace the fan with a corresponding 60x60x10 mm fan.
Carefully open the fan cover as shown as below.
Manual IB-RD3802-C31
Werbung
Inhaltsverzeichnis
