Cleaning And Maintenance - Elektrabregenz DB 6043 Benutzerhandbuch

4

Cleaning and Maintenance

CAUTION
Risk of damage due to the corrosion da-
mage. Always operate the appliance while
cooking in order to prevent condensate
formation. Condensate may cause corro-
sion damage. Replace immediately the fa-
ulty lamps in order to prevent other lamps
from being overloaded. The risk of damage
A
occurs due to the humidity intrusion to the
electronics. Never clean the controllers with
a wet cloth. Surface may be damaged due
to improper cleaning. Clean the stainless
steel surfaces only in the direction of brus-
hing. Do not use stainless steel cleaner for
controllers. The surface may be damaged
due to abrasive or rubbing cleaning agents.
Never use abrasive or rubbing cleaning
agents. There is the risk of damage due to
backflow of condensate. Install the air outlet
A
CAUTION
You can use this appliance in waste air
mode and in air circulation mode.
Waste air mode
Absorbed air is cleaned by oil filters and
expelled by means of a piping system. (Pic.
A
3) If you want to transfer the waste air to a
disabled smoke or waste gas flue, you have
to obtain permission from an authorised flue
cleaning specialist. If the waste air is expelled
over the external wall, a telescopic wall frame
should be used.
C
Absorbed air is cleaned by oil filters and an
active carbon filter and retransferred to the
kitchen. Pic. 4
NOTE!
C
The waste air should not be transferred to a
smoke or waste gas flue, nor to a flue used
for ventilation of the places where heating
sources are installed.
32 / EN
To seal the materials causing odour in the
circulating air mode, you should install an
active carbon filter. Consult your authorised
C
dealer to learn different opportunities for
operating the appliance in the circulating
air mode. You can buy accessories neces-
sary for this procedure from relevant points
of sale, authorised service agents or online
sales centre.
The appliance you have purchased is suitable for use with car-
bon filter. To attach the carbon filter;
1- Place the carbon filter into its housing. Pic. 15/1
2- Turn the carbon filter clockwise to make sure that it is
tightly inserted. Pic. 15/2
Res.13 Res.14
C
If the carbon filter is not properly attached, it
can fall and damage your product.
A
CAUTION
Never wash the carbon filters. Keep the car-
bon filters away from children.
CAUTION
A
Cleaning and user maintenance should not
be performed by children without supervi-
sion.
• The surface may be damaged due to abrasive or rubbing
cleaning agents. Never use abrasive and rubbing cleaning
agents. Acquire the cleaning agents and protective materials
suitable for your appliance form your authorised service. The
surface of the appliance and the controllers are sensitive to
scratching.
• Clean the surfaces with a soft and damp cloth, dishwashing
liquid or a soft glass cleaning agent. Soften the dried and
adhered dirt with a damp cloth. Do not scratch out!
• Dry cloths, sponges that may scratch, materials that requ-
Res.15
Hood / User Manual