Rexel AUTO+ 300X Bedienungsanleitung Seite 12

GB
over heating
If the Auto+ 300X and 300M is used continuously for over 16 minutes the shredder may overheat
and the cool down indicator will flash red (
the shredder is ready to be used the thermometer symbol will no longer illuminate. If the shredder
needs to cool down while shredding, no action is needed. The shredder will automatically restart
shredding paper once it has cooled down after periods of continuous use. All you need to do is
ensure paper is loaded into the chamber and the bin is empty when the machine is cooling down.
7. self-cleaning cutters
After emptying and replacing a full bin, the shredder will run in forward for 4 seconds, stop for
2 seconds and then reverse for 4 seconds to clear away any remaining paper from the cutter
mechanism. This unique 'self-cleaning' mechanism is additional jam prevention technology
from Rexel.
lubrication of the shredder
Only use Rexel Oil Sheets (2101948 & 2101949) to lubricate. ACCO Brands Europe accepts no
liability for product performance or safety when other types or brands of lubricants are used on any
part(s) of this machine. Rexel recommend using an oil sheet after the bin has been emptied three
times (and for on-going three bin cycle thereafter). Insert the oil sheet into the manual feed slot and
NOT in the auto-feed chamber. Using an oil sheet in the auto-feed chamber will contaminate the
feed rollers preventing the auto-feed mechanism shredding. Follow the maintenance instructions if
the rollers become contaminated.
8. maintenance
The rollers on the auto-feed mechanism may become dirty over time, please wipe clean with a dry
cloth to maintain maximum product performance.
The auto-start infra-red sensor, located in the paper feed entry-slot, can occasionally become
covered in paper-dust causing the shredder to run despite no paper being fed into the machine.
Switch the shredder off at the rear of the machine and carefully clean the sensor using a cotton-
swab.
service
We recommend these machines are serviced every 6 to 12 months by a Rexel service engineer –
see back of this booklet for the contact details of your local service centre and for enquiries about
maintenance contracts.
shredder accessories
We recommend that a paper waste sack for
recycling shredded paper is used on all models.
12
register this product online at www.accobrands.com
). Please allow the shredder to cool down. When
Accessory Part Number
Recycling Waste 1765029EU
Sack
Plastic Waste
Sack
Oil Sheets
Box Quantity
20
40040 100
2101949 20
2101948 12