Whirlpool ADN 200/1 Betriebsanleitung, Produktdatenblatt Seite 4

Air the room in which the appliance is placed for a few minutes (the size of the
•
room for a product containing isobuthane / R600a must be at least 4 m
damage to the cooling system.
C-Pentane is used as blowing agent in theinsulation foam and it is a
flammable gas.
This appliance is not designed for the storage of explosive substances such as
–
aerosol cans with a flammable propellant.
It is prohibited to store petrol and other flammable liquids near the appliance.
–
The appliance should be used only for storing foodstuffs
–
Once the appliance is unpacked, make sure that it is complete, that the body
–
and the electrical cord aren't damaged. It is forbidden to use a technically
damaged appliance.
The appliance should only be connected to an earthed socket installed in
–
accordance with the regulations. Make sure that the supply voltage corresponds
with the voltage marked on the rating label. This product complies with all
binding CE labelling directives. The earthed electrical socket by which the
appliance is connected to the mains should be in an accessible place. It is a
legal requirement that the appliance is properly earthed. The manufacturer will
not be held liable for any damage or injury which may result from the failure to
fulfil this requirement.
To avoid the exposure to danger, always have faulty cable be replaced only by
–
the manufacturer, by our customer service or by qualified person and with a
cable of the same type.
Do not use adapters, multiple sockets and two-wire extension leads. If it is
–
necessary to use the extension lead, it must be equipped with a protection ring
and a single socket and must have a VDE/GS safety certificate.
The frequency and power of the electricity supply must conform to the general
–
data parameters of the appliance as it is shown in the product label.
When positioning the appliance, be careful that the electrical cord isn't
–
squeezed in order to avoid its damage. Do not store heavy objects such as
cooling devices, furniture or other devices next the appliance in such a way that
they could squeeze and damage the electrical cord. This can cause a short
circuit and a fire.
Make sure that the plug of the electrical cord is not squeezed by the back wall
–
of the appliance or otherwise damaged. A damaged plug can be the cause of a
fire!
3
) to avoid
3