Cleaning, Maintenance And Ordering Of Spare Parts - Levita LM 32K Bedienungsanleitung

d) Hints for optimum use
◆ If the grass is longer than approximately 10 cm, make two cuts to obtain a better finish. At first
mow at maximum height of cut and then adjust to a low or medium height of cut.
◆ In order to achieve optimum results, only mow dry grass.
7. Technical data
Model
Type
Voltage (V~ / Hz)
Power Input (W)
No-Load Speed (min
Height adjustment (mm)
Width of cut (mm)
Grass box volume (l)
Weight (kg)
Class of insulation / Class of protection
Sound pressure L (dB(A)) / K (dB(A))
pA
Sound power level L
Vibration level a (m/s
hv

8. Cleaning, maintenance and ordering of spare parts

Warning! Before proceeding, remove the plug from the socket.
a) Cleaning

Keep all safety devices, air vents of the motor hood free of dirt and dust as far as possible. Use a
clean cloth or compressed air at low pressure.

We recommend that you clean the device immediately each time you have finished using it.

Regularly clean the equipment with a moist cloth and some soft soap. Do not use abrasive
cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no
water can seep into the device.

Never clean the mower (except grass box separated from the mower) by stream of water or a
pressure washer.
b) Checking and replacing the cutting blade (Fig. G)
For safety reasons, we recommend having the blade replaced by an authorized person.
Warning! Ensure the blade has completely stopped and the appliance disconnected from the mains.
Warning! Use only use the original spare blade.
Important! Wear heavy-duty work gloves to grip the blade!
Blade maintenance
◆ If the blade is dull, sharpen it or replace it with a new one.
◆ To sharpen the blade, remove the blade from the mower (see below), clamp it in a vice and file the
cutting edge evenly. Be careful when grinding on each side as well. Before installing the blade into
the mower, check its balance. An unbalanced blade is the cause of increased vibration with risk of
damage of the mower.
◆ If the blade is damaged, immediately replace it with a new one.
To remove the blade:
◆ Turn the appliance onto its side.
◆ Using heavy-duty gloves, grip the blade (1).
◆ Use the correct spanner and remove the blade bolt (2) by turning the spanner anti-clockwise.
22 / 30
-1
)
(dB(A)) measured / guaranteed
wA
2 2
) / K (m/ s )
LM 32 K
SF7A113-2 SF7A102-02
220-240 / 50 220-240 / 50
1000
3300
25 / 43 / 62 25 / 43 / 62
320
30
9,8
II / IPX4
78,9 / 3
89 / 96
2,60 / 1,5
LM 32 A
1000
2800
320
30
12,1
II / IPX4
75,1 / 3
87,2 / 93
0,789 / 1,5