auna DigiPlug UP Handbuch Seite 18

EN
18
Preset memory stations
You can store 10 FM stations in the memory
1. Turn to the desired radio station by " manual" or "auto" tuning method.
2. Press and Hold Preset button (8b) at Remote until the LCD show Preset
Store <1: ......Hz>
3. Then press Up/down button (8f) to select memory position (from 1 to
10).
4. Press ENTER button (8g) to confirm the program
5. Repeat above 1-4 to preset all desire station
Recall preset memory
1. Press the Preset button (8b) at Remote and LCD will show Preset Recall
<1: ......Hz>
2. Then press Up/down button (8f) to select the desire memory (from 1 to
10).
3. Press ENTER button (8g) to call out the preset station
Display information
Keep Pressing the Menu/Info button (8b) at remote, the LCD will show
difference information such as RDS information from Board casting, Time
and Date etc.
Scan setting
By default, FM scans stop at any available station, this may result in a poor
signal-to-noise from weak station, it can be change the scan setting to stop
only at good signal strength station.
1. Press and Hold the Menu button (8b) at remote until it enter the Manu
mode
2. then press up/down button (8f) to select 'Scan setting' then press
ENTER button (8g) to enter.
3. Press up/down (8f) to select 'Strong station" then press ENTER button
(8g) to confirm.