Installation Of Scale; Operation - ADE M111600 Bedienungsanleitung

Your ADE electronic baby hanging scale is a quality product. In order to get the most accurate results please
read and respect the instructions of the Operating Manual.
Insert batteries
-
-
-
-
-
Display function keys
There are 4 function keys on this scale.
-
-
-
-
Weighing
3.
4. You may now weigh the good. Make sure to use a weighing bag. The material absolutely has to be a
Tare function
Choosing this function you may weigh the baby together with different objects (e.g. nappy, vest etc.) and the
weighing bag or – trouser without influencing the weight result.
-
-
-
-
-
-
-
-
Change unit
Should you prefer to weigh in another weighing mode than kg you might change into another mode (lb, oz or
indication of room temperature). In this case press SET key and choose preferred mode. Make sure the scale
has been started before by pressing ON and the displays shows `0.00´.
5
Downloaded from www.Manualslib.com
Please use two (2) CR2032 (lithium) batteries.
Open the battery compartment on the back side of the scale by loosening the fixing screws carefully.
Insert the batteries by respecting the polarity markings (+-).
Please ensure that the battery compartment cover is being screwed in place before starting a function
test.
When disposing of disused batteries, observe the valid legal and municipal regulations
Key ON to start the scale.
Key OFF to switch off the scale.
Key SET to change the weighing mode from kg to lb or to check the room temperature.
Key TARE to reset the scale to zero after weighing procedure.
To achieve a reliable result make sure the scale is placed in a vertical position and no load is
hanging at the hook.
Press ON key to start the scale. During an automatic zero setting you will see the indication `8888´,
displayed before to come to `0.00´ in kg weighing mode.
very strong fabric (like canvas) for safety reason. It must be 100% tear proof.
Press ON and wait for `0.00´indication on the display.
Weighing bag or trouser including objects (nappy, vest etc.) to be placed on the hook.
Press TARE to reset scale to zero.
Take all objects away from the scale and press SET. The scale will now show only the weight of the
weighing bag as negative value. Place the baby incl. objects carefully in the weighing bag or trouser
and hang with utmost attention on the hook. Do not swing the baby hanging in the bag.
The scale will now display the weight of the baby only.
After the weighing procedure make sure the baby is safely secured in its cradle.
Press OFF to disconnect the scale from power.
Additionally the scale is equipped with an automatic shut off after 60 seconds without being loaded to
prolong the lifetime of the batteries.
manuals search engine

Installation of scale

Operation

M111600-120206-Rev001-UM-d-e