General Information; Installation Of Scale; Operation - ADE M111600 Gebrauchsanweisung

Your ADE electronic baby hanging scale is a quality product. In order to get the most accurate
results please read and respect the instructions of the operating manual.
This symbol means: "Consult operating instructions". Read the instructions for use carefully
before use and keep them for future reference.
Insert batteries
Please use two 2 x CR2032 (lithium) batteries.
-
Open the battery compartment on the back side of the scale by loosening the fixing screws carefully.
-
Insert the batteries according to the pole markings (+ -), with the + pole of both batteries pointing
-
towards the bottom of the battery compartment.
Please ensure that the battery compartment cover is in place and secured via the fixing screws
-
before starting up the scale.
Please observe the valid legal regulations in your country, when disposing used batteries.
-
Function keys
There are 4 function keys on this scale.
Key ON/OFF to start or switch off the scale.
-
Key HOLD to activate / deactivate the automatic hold function.
-
Key SET to change the weighing mode from kg / lb / oz or to check
-
the room temperature.
Key TARE to reset the scale to zero.
-
Weighing
To achieve a reliable result, make sure the scale is placed in a vertical position and no
load is hanging at the hook.
1. Press the ON/OFF key to start the scale. During the automatic zero and function test you will see
the indication `8888´ in the display before `0.00´ will come up in kg mode.
2. You may now use the scale. Make sure to use a weighing trouser or cloth supplied as optional extra
by ADE.
3. To switch the scale off press the ON/OFF key again. Additionally, the scale is equipped with an
automatic shut off function. Shutting down the scale after 60 seconds without use.
Tare function
Choosing this function, you may weigh the baby together with additional objects (e.g. nappy, vest etc.)
and the weighing trouser or cloth without influencing the net weight result of the baby.
Press ON and wait for `0.00´ indication on the display.
-
Hang the weighing cloth or trouser including other possible objects (nappy, vest etc.) at the hook.
-
Press TARE to reset the scale to zero.
-
Remove all weights from the hook. The scale will now display the weight as negative value and will
-
hold the weight automatically.
Place the baby in the weighing trouser or cloth and hook it up to the scale. Press the HOLD key to
-
restart the weighing function. The scale will show the next weight of the baby.
To cancel all values, press TARE again or switch off the scale.
-
5

General Information

Installation of scale

Operation

M111600-201007-Rev005-UM-de-e