Cleaning, Care And Maintenance; Troubleshooting; Installation; Safety - STIEBEL ELTRON CK 20 trend Bedienungs Und Installationsanleitung Handbuch

INsTALLATIoN

Cleaning, care and maintenance

5. Cleaning, care and maintenance
- Clean the appliance when cold with domestic cleaning
products.
- Never use any abrasive or corrosive cleaning products. Never
spray cleaning spray into the air slot.
- If a pale brownish discolouration appears on the appliance
casing, wipe it off with a damp cloth.
Dust filter cleaning
- Clean the dust filter at regular intervals. The dust filter can
be pulled out from the side of the appliance.
You may need to detach the appliance from the wall mount-
ing bracket beforehand (see chapter "Preparations / Installa-
tion site").
6.

Troubleshooting

Problem Cause
The appliance does The dust filter is heavily
not deliver the re- soiled.
quired heating output.
The appliance does The temperature has
not heat up. been set too low on the
appliance.
Fuse or safety switch has
blown/tripped.
Overheating. High limit
safety cut-out has re-
sponded.
Fuse has blown.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
14 | CK 20 trend
remedy
Check and, if necessary,
clean the dust filter.
Check the temperature set
on the appliance.
Check the fuse/MCB in your
fuse box/distribution panel.
Eliminate the cause (dirt or
obstructions at the air inlet
or outlet).
Appliance cannot be re-
started.
INsTALLATIoN
7.

Safety

Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
- Install the appliance in such a way that control equipment
cannot be touched by a person in the bath or shower.
- All electrical connection and installation work must be car-
ried out in accordance with VDE regulations (DIN VDE 0100)
[or local regulations], the rules of your local power supply
utility, and relevant national and local regulations.
- Only mount the appliance on a vertical wall that is tempera-
ture-resistant to at least 85 °C.
- Maintain minimum clearances to adjacent surfaces.
- Ensure the on-site cable has an adequate cross-section.
- When connecting the appliance via a standard socket, ensure
that the socket is easily accessible once the appliance has
been installed.
- Never install the appliance directly below a wall socket.
- When installing the heating appliance in rooms with a bath
or shower, observe the safety zone according to VDE 0100,
section 701 [or local regulations], in accordance with the de-
tails on the appliance type plate.
- Observe the type plate. The specified voltage must match the
mains voltage.
- Observe the Building and Garage Regulations [or local
regulations]
8.

Appliance description

8.1

Standard delivery

The following are delivered with the appliance:
- 1 wall mounting bracket
8.2

Accessories

- Towel holder
www.stiebel-eltron.com