Hardware Setup; Preliminary Settings - Velleman CCTVPROM17 Schnelleinstieg

Rear panel
PUSH VIDEO
Alarm In
DC 19V
5.

Hardware Setup

Connecting a Video Monitor
Obtain a suitable monitor (not included) and connect it to the MONITOR, HDMI, or VGA video output port on the
back of the DVR.
Note: You can use the MONITOR, HDMI, and VGA output ports simultaneously.
Connecting the Power Supply
1. Plug the DC output connector of the included power adaptor into the 19 VDC power input at the back of the
DVR.
Caution: Only use the included adaptor.
2. Plug the included power cable into the adaptor input connector and plug the other end into the mains. Do
not switch the DVR on yet.
Connecting a Camera
1. Obtain up to 8 suitable cameras (not included). Each camera needs its own power supply.
2. Connect the video output of the camera to either video input at the back of the DVR. The number next to
the input connectors represents the channel number. Connector type is BNC.
Connecting Audio
1. The DVR supports four audio inputs. Connect the audio output of an audio source to an audio input of the
DVR. Make sure to connect the audio channel to the corresponding video channel. Connector type is BNC.
2. There is also an audio output connector. Connect an audio device, e.g. a speaker, to this connector when
desired. Connector type is BNC.
Connecting Local Area Network (LAN)
Connect the DVR to a local network by plugging a network cable into the LAN port at the back of the DVR.
Connector type is 8P8C (RJ45). Setup is done through the OSD.
Connecting a USB Mouse
Connect a USB mouse to the right USB input port (
6.

Preliminary Settings

Make sure the connected cameras are on and set the power switch at the rear of the device to the on position.
The device takes about 15 to 30 seconds to start up.
Menu Overview
1. Press the MENU button and enter the password to open the menu.
Note: The default admin password is "0000" (4 times zero).
2. Right-click anywhere on the screen to open the main menu. Right-click again to close.
V. 02 – 28/08/2013
Downloaded from www.Manualslib.com
Connect an alarm device for event notifications to your smart phone (push video). The
alarm input 1 corresponds with video input 1.
power supply input
power switch
manuals search engine
CCTVPROM17
) of the front panel.
5 ©Velleman nv