Hardware-Setup - Velleman CCTVPROM9 Schnelleinstieg

•
VGA interface built-in
•
backup function: supports USB 2.0 flash drive backup
•
remote surveillance on mobile phone via 3G/GPRS or on PC through internet connection
•
motion trigger recording
•
multi-language OSD: English, French, Dutch, German, Portuguese, Spanish, Czech, Hungarian, Greek,
Italian, Arabic, Polish, Vietnamese and Chinese
•
A/V support: supports 4 audio inputs and 1 audio output for sound recording
•
supports SATA HDD
•
PTZ control: supports PELCO-D protocol
•
alarm I/O: 4 inputs, 1 output
•
supports daylight-saving function
•
supports manual / timer / motion / network recording functions
•
system auto recovery after power reconnected
•
supports TCP/IP, PPPoE, DHCP and DDNS network connection
•
optional monitor (not incl.): MONSCA4, MONSCA5
•
4x IR bullet colour cameras
5. Overview
Refer to the illustrations on page 2 of this manual.
Front panel
LED
indications
1 ~4
PLAY
LIST
ENTER
MENU
SLOW
ZOOM
AUDIO
SEQ
PAUSE
/ +
STOP
/ -
REW
FF
USB
Note: do not connect two USB flash drives or USB mice at the same time.
rear panel
VIDEO IN
MONITOR
AUDIO IN
AUDIO OUT
LAN port
VGA
EXTERNAL I/O
19V DC
6. Hardware setup
Connecting a video monitor
•
Obtain a suitable monitor (not included) and connect it to the BNC or VGA video output port on the back of
the DVR.
Note: when both a CRT and VGA monitor are connected, press and hold the
force the output to the CRT monitor port.
23/11/2010
Downloaded from www.Manualslib.com
HDD reading or recording activities on the hard disk
POWER DVR power is on
Press a button to select the corresponding channel.
4CH: Press to show the 4 channel display mode.
Press to play the recorded video.
List the information of the recorded files.
QUICK SEARCH / RECORD / MOTION / ALARM / TIMER / FULL LIST
Press to confirm settings
Press to enter the main menu.
In playback mode, press to play the recorded file slowly.
Press to enlarge the image of the selected channel.
= SLOW + ZOOM
Press SLOW and ZOOM simultaneous to select live or play-back sounds.
Press to show all screens sequentially in full screen mode. Press again to quit.
Press to pause, press again to continue playback.
Press to move up ( ) or increase value (+)
Press to stop playback.
Press to move down ( ) or decrease value (-)
Press to rewind.
Press to move left ( ).
Press for fast forward.
Press to move right ( ).
Connect a USB flash drive for video backup to this USB port.
Connect a USB mouse to this USB port.
4 video input channels to connect 4 external video sources.
connect a CRT monitor to this output
1 audio input channel to connect an external audio source e.g. from a camera with audio.
1 audio output to connect to an audio device, e.g. a speaker (mono).
Connect the DVR to a local network by plugging a network cable into this port.
connector for video monitor
use a 9 pin DSUB connector to connect external signals e.g. alarm, sensor, ...
Power supply input.
manuals search engine
CCTVPROM9
5
button during start-up to
©Velleman nv