Märzhäuser Wetzlar LED 100 cw Betriebsanleitung Seite 80

Service
1 Switch off the TANGO controller/DSU-1 and microscope.
2 Unmount the LED 100 from the microscope.
3 Remove the 4 fixing screws from the back of the LED 100
4 Carefully pull out the cable holder with the LED module.
78
(Allen key 2).
If necessary, carefully press the LED module out through the
mounting hole on the opposite side of the LED 100 using
the Allen key 2.
Note: Do not pull on the cable.
Operating Manual