Troubleshooting; Display Problems; Technical Specifications - BELINEA 10 30 26 Bedienungsanleitung

ENGLISH

TROUBLESHOOTING

Blank Screen
Power indicator is off
- Check if the power cable is connected properly (see section "Connecting").
- Make sure that the monitor was turned on using the power switch (see section "Startup").
Power indicator lights orange or is flashing
- Perhaps a power saving mode is active?
Power indicator lights green
- A screen saver may have activated automatically after a certain period of inactivity. Press any key on your keyboard or
move the mouse.
RGB bars
- Make sure the signal cable is connected to the PC's VGA connector (see section "Connecting").
- Is the PC turned on (see section "Startup")?

Display Problems

Image is displaced to the left/right or to the top/bottom
- If the image is displayed normally but not centered correctly, you can adjust its position using the OSD functions. For
more information on this topic consult the functions "V. Position" and "H. Position" in the "OSD Menu Functions" section.
Image flickers or is shaky
- If the image is displayed normally but appears slightly shaky, the vertical frequency might be too low. Select a higher
frequency. For more information on this topic consult the user's guide of your PC, graphics card or operating system.
- Perhaps setup file chosen for the monitor is incorrect. For information on monitor setup under Windows
XP consult the "Configuration" section.
Image is blurred
- Check brightness and contrast settings (see section "Basic Setup").
- If the vertical frequency is too high, the image might be slightly blurred. In this case lower the frequency.
Color problems
- If the colors are distorted in some areas, you should demagnetize your monitor (see "Degauss" function in section "OSD
Menu Functions").
- If the colors are off (e.g. white is not really displayed as white etc), you should adjust the color temperature (see "Color"
function in section "OSD Menu Functions").
- Devices generating magnetic fields, such as laser printers and loudspeakers, shouldn't be placed near the monitor
since they might affect image quality.
Image edges distorted
- If the image is slightly distorted, bent or tilted at the edges or the entire image is not aligned horizontally, you can correct
this using the OSD menu functions (see "Trapezoid" "Parallel" "Top/Bottom Corner" and "Rotation" functions in section
"OSD Menu Functions").

TECHNICAL SPECIFICATIONS

Picture tube
Input signal
Display colors
Synchronization
Video bandwith
Resolution
Power supply
Power consumption
Dimensions / weight
Operating environment
14 - Belinea 10 30 26
Downloaded from www.Manualslib.com
17 inches diagonal size (40.3 cm visible),
dot pitch diagonal/horizontal: 0.27mm/0.23mm
glare-free coating, low emissions according to TCO 99, phosphorus type P22
analog 0.7 Vpp, 75 Ohm, positive, Synchronization: separate, TTL level
unlimited colors
30 – 70 kHz horizontal, 50 – 160 Hz vertical
110 MHz
max. resolution 1280 × 1024, ergonomic resolution 1024 × 768 (85 Hz)
100 – 240 VAC, 50/60 Hz
ON status: max. 75 W; color of the status LED: green
SLEEP status: < 2 W; color of the status LED: orange
Power saving functions EPA certified
Width: 404mm, height: 407.4mm, depth: 423.2mm (monitor only), 13.9 kg (monitor only)
Operation: 0 – 35 °C, humidity: 10 – 90 % (without condensation)
Storage: -25 – 60 °C, humidity: 10 – 90 % (without condensation)
manuals search engine
®
9x/ME/2000 or