Hama Quixotic Benutzerhandbuch Seite 10

00034313bda_DIN_A6
Macro Button
With this button you can program a complicated move requiring many buttons. You
can recall this move by pressing a single button. See point "Programming of the
Controller" in this instruction manual.
Button Programmability:
Certain buttons of the controller can be programmed. One distinguishes between pro-
grammable and non-programmable buttons. The direction pad, right-thumb-controlled
analogue sticks as well as the buttons START and MACRO are non-programmable;
they cannot be set to any function button.
Note: The Quixotic Controller must be plugged into the GameCube console so that the
buttons can be relocated and programmed; during the programming, no games are
possible.
What does button programmability signify?
The Quixotic Controller is fully programmable. This allows you to perform on demand
special and complex moves more quickly. When playing certain games (usually figh-
ting games), a combination of function buttons executes special moves for more intri-
cate attacks. The macro function allows you to execute these complicated moves by
pressing a single button.
Three buttons can be occupied for the reproduction of set macros: L-Button, R-Button,
and Trigger (see controller diagram). In every programmed macro, up to 32 buttons
can be pressed. Pressing buttons simultaneously counts as a single command (pres-
sing X, B, and A e.g. at the same time is one command, not three commands). When
programming a button, every button pressed is registered to the pad as 100%. Your
commands must be executed within 1.5 seconds.
Programming of the controller:
1. Press the MACRO button until the MACRO LED lights up and indicates that the
programming function is active. Note: Press the START button to adjust the
executing speed of the programmed buttons. The MACRO LED flashes at two
intervals: 0.6 sec and 1.2 sec.
2. Select the button to be programmed by pressing that button(Z key or button under
digital controller) until the MACRO LED begins to flash.
3. Press the button(s) (A, B, X, Y, Trigger, L-Button, R-Button and left-thumb-controlled
analogue sticks) to be programmed into the button which was selected above.
Each button pressed during this step is acknowledged by one blink of the MACRO
LED. Note: When the maximum number of buttons for the programming (32) is
pressed, controller does not accept further inputs and the MACRO LED goes out.
4. Press the MACRO button to turn the programming function OFF when you have
assigned the desired buttons. The MACRO LED goes out.
5. Repeat the above-mentioned points to program other buttons.
Downloaded from www.Manualslib.com
10.08.2006
manuals search engine
16:14 Uhr Seite 11
9