Buzzer On/Off; Before First Use - AEG TP7051TW Benutzerinformation

7.2 Adjustment of remaining
laundry moisture
Every time you enter in the
"Adjustment of remaining
laundry moisture" mode,
previously set degree of
remaining moisture will
change into next value ( e.g
previously set
change into
To change the default degree of
remaining moisture:
1. Press the on/off button to activate the
appliance.
2. Use the programme knob to set any
programme.
3. Wait approximately 8 seconds.
4. Press and hold buttons (E) and (D) at
the same time.
One of these indicators comes on:
•
•
•
5. Press and hold buttons (E) and (D)
again until the indicator of the correct
level comes on.
If the display returns to
the normal mode (the
time of the selected
programme from step 2.
will be displayed), while
setting the degree of
remaining moisture,
press and hold buttons
(E) and (D) once again
to enter to the
"Adjustment of remaining
laundry moisture" mode
(previously set degree of
remaining moisture will
change into next value).

8. BEFORE FIRST USE

Rear drum locks are
removed automatically when
dryer is activated for the first
time. Possible to hear some
noise.
will
).
the maximum dryness
the more dry laundry
the standard dry laundry
6. After 5 s the display returns to normal
mode.
7.3 Water container indicator
By default, the water container indicator
is on. It comes on when the programme
is completed or when it is necessary to
empty the water container.
If a draining kit is installed
(additional accessory), the
appliance automatically
drains the water from the
water container. In this case
we recommend that you
deactivate the indicator of
the water container.
Deactivating the water
container indicator:
1. Press the on/off button to activate the
appliance.
2. Wait approximately 8 seconds.
3. Press and hold touch buttons (B) and
(D) at the same time.
The display shows one of these 2
configurations:
• The display shows "Off". After 5 s
the display returns to normal
mode.
• The display shows "On". After 5 s
the display returns to normal
mode.

7.4 Buzzer on/off

To deactivate or activate the acoustic
signals, press and hold for approximately
2 seconds touch buttons (A) and (B) at
the same time.
ENGLISH 13