Kidwell BENTO Benutzerhandbuch Seite 17

PARTS (see page no.3)
1 Seat
Top layer of tray
2
Bottom layer of tray
3
4 Leg divider
ASSEMBLY
1
The seat comes already assembled with the frame. To unfold the frame press and
hold the buttons on both sides of the mechanism
2
Adjusting the seat height
At the same time, press and hold the adjustment buttons on the sides of the chair.
There are 8 levels to choose from.
WARNING: Before the child sits on the chair, make sure that both sides of the chair
are at the same height level. Otherwise, the child could be exposed to danger and the
product to damage
WARNING: Do not adjust the seat height when the child is sitting in it.
3
To lock the feeding tray, pull and hold the handle on the bottom in the center of the tray.
Then slide the tray into the guides. The guide slots should be at the same level, the
guides can be adjusted manually before installing the tray. By releasing the handle,
the tray will lock in one of two possible positions
The feeding tray has an additional level only for storage
WARNING: the tray can not be in used when it is in the storage position (most
extended position)
WARNING: make sure the tray is locked in one of two positions by moving it gently. If
the tray does not move, it means that the lock is active.
4
To attach the protection, start by sliding it into the slot at the front of the seat so
that the protruding element at the base of the protection hits the hole. The protection
should then be pressed inwards. When inserted correctly, it will emit a "click" sound.
To remove the protection, tilt it slightly towards the backrest with the other hand while
pushing the front of the seat to pivot the lock, then pull it towards you.
5
Pull the safety belts out by pushing it through the belt loops that are under the seat.
To remove the safety belts from the back of the backrest, grab the protruding safety
belt element and pull, the oval belt hook will pop out of the securing device, then pass
5 Legrest
6 Unfolding mechanism
7 Frame
8 Lower frame casing
17