Ec Declaration Of Conformity - Ego Power+ ST1210E Bedienungsanleitung

NOTICE:
Always clean the spool retainer, spool and spool
base before reassembling the trimmer head. Check the
spool retainer, spool and spool base for wear. If necessary,
EN
replace the wear parts.
NOTICE:
Failure to wind the line in the direction indicated
will cause the trimmer head to operate incorrectly.
Install a pre-wound spool
Press the two release tabs on the spool base and pull the
spool retainer out (Fig. S). Then place a pre-wound spool
into the retainer with notches aligned with retainer eyelets
(Fig. W). Lastly, align the retainer slots with the tabs on the
spoon base and press the retainer evenly down, ensuring
that it snaps into place (Fig. X).
Fig. W & X parts description see below:
W-1 Notch
W-2 Eyelet
NOTICE:
Make sure that the tabs on the spool base snap
into place or the spool will come out during operation.
MAINTENANCE
WARNING:
When servicing, use only identical
replacement parts. Inspect and maintain the machine
regularly. To ensure safety and reliability, all repairs should
be performed by a qualified service technician.
WARNING:
Battery tools do not have to be plugged into
an electrical outlet; therefore, they are always in operating
condition. To prevent serious personal injury, take extra
precautions and care when performing maintenance, service
or for changing the cutting attachment or other attachments.
WARNING:
To prevent serious personal injury,
remove the battery pack from the tool before servicing,
cleaning, changing add-on attachments or removing
material from the unit.
CLEANING THE UNIT
◾
Clean the unit using a damp cloth with a mild detergent.
◾
Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by
certain aromatic oils, such as pine and lemon, and by
solvents such as kerosene. Moisture can also cause
a shock hazard. Wipe off any moisture with a soft dry
cloth.
◾
Use a small brush or the air discharge of a small
vacuum cleaner brush to clean the air vents free of
obstructions on the rear housing.
12
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1210E
X-1 Tab
X-2 Slot
STORING THE UNIT
◾
Remove the battery pack from the line trimmer when
it is not in use.
◾
Clean the tool thoroughly before storing it.
◾
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, petrol, or other
chemicals.
Protecting the environment
Do not dispose of electrical equipment,
battery charger and batteries/rechargeable
batteries into household waste!
According to the European law 2012/19/
EU, electrical and electronic equipment
that is no longer usable,and according to
the European law 2006/66/EC, defective
or used battery packs/batteries, must be
collected separately.
If electrical appliances are disposed of in
landfills or dumps, hazardous substances
can leak into the groundwater and get
into the food chain, damaging your health
and well-being.

EC DECLARATION OF CONFORMITY

We, CHERVON EUROPE LTD.
47 CASTLE STREET, READING, RG1 7SR, UNITED KINGDOM
Declare that the product 56V lithium-ion cordless line
trimmer ST1210E complies with the essential health
and safety requirements of the following Directives:
2006/42/EC, 2014/30/EU, 2011/65/EU, 2000/14/EC
Standards and technical specifications referred to:
EN 60335-1, EN 50636-2-91, EN 62233, EN 55014-1,
EN 55014-2
Measured Sound Power Level: 90.76 dB(A).
Guaranteed Sound Power Level: 91 dB(A).
Peter Melrose
Vice President of Chervon Europe
* (Authorized representative for CHERVON and responsible for technical documentation)
01/04/2016
Dong Jianxun
Quality Manager of Chervon