Wolf Garten Power Edition 40 B Gebrauchsanweisung Seite 14

Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Starter cord assembly
1. Lift and hold operator presence bail arm
2. Pull the starter rope slowly to the holding bracket.
Twist the cord through the holder
3.
3
Always remove the starter cord from the holder before
folding the mower handles.
Oil Fill
H
1
Check oil level with mower standing on level ground.
Fill crankcase with quality oil SAE 30 up to the mark „Full"
on dipstick. (Do not overfill.) Capacity approx. 0,6 litre.
Screw in dipstick according to illus.
Filling with fuel
1
Caution! Rotating blades
Settings only to be carried out on the machine with the mo-
tor switched off and with the working tools at a standstill.
Use only normal lead-free petrol (not Super unleaded).
Avoid spilling petrol.
Do not inhale the vapour.
Hang up collection bag
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the re-
cesses (see arrow).
3. Replace the protective flap.
Set cut height
K
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
1. Place hand into handle bar and depress button (1).
2. Lift or lower chassis until it engages into required position (2).
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do
not se cutting position too low when mowing very hight or wet
grass.
We recommend an average cutting height of 40-50 mm.
14
F (2).
.
G
J
Start
On a flat surface, if possible not in high grass.
F
1. Throttle lever (1) to "Betrieb" (= running).
2. Raise and hold the safety bracket
G
3. Pull starter grip and return it slowly by hand.
Wheel drive (Power Edition 40 BA, Power Edition 46 BA)
1. Wheel drive on: Raise drive bracket
2. Wheel drive off: Relapse drive bracket
Stop Motor
Release safety bracket
3
If the motor does not start in cold weather, press the
primer.
Emptying of Grassbox
When the collection bag is full, the flap lowers by itself.
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Empty collection bag.
Remove potential blockages in the cutting space before
starting.
3
Instructions for level indicator:
For an efficient functioning of the level indicator, regularly
clean the holes under the level indicator in the collection
bag with a hand brush.
Tips for mowing
To prevent strips of grass from being left unmowed, the cutting
paths must always overlap a few centimeters
F
(2).
F (3).
F
(3).
(2).
F
L
M .
G